Complete Power Steering Rack And Pinion Assembly For 2012 Ram 1500 Outdoorsman
Posted on December 11, 2022 | By admin
Steering gear, also called steering gear, is the most important part of automobile steering system. Power steering (PAS) or steering assist system helps drivers steer by augmenting steering effort of the steering wheel. Power steering rack and pinion is the most important part for vehicle swerving and security assurance. It converts the rotational motion of the steering wheel into the linear motion needed to turn the wheels and provides a gear reduction. Thus making it easier to turn the wheels. Complete Power Steering Rack and Pinion Assembly For 2012 Ram 1500 Outdoorsman. Also called steering gear, is the most important part of automobile steering system. Or steering assist system helps drivers steer by augmenting steering effort of the steering wheel. Power steering rack and pinion. Is the most important part for vehicle swerving and security assurance. In use and daily maintenance, we should pay attention to the following points to extend the service life of the steering machine. When driving on the potholed and uneven road, slow down and reduce the load borne by the. Frequently check the protective sleeves on both sides of the. And the protective sleeves on the upper part of the steering machine connected with the universal cross. The damage of the sheath is the main factor that causes the early wear and damage of the. After the sheath is damaged, water and dust and sand will enter the. Through the damaged part, damaging the lubricating grease film of the gear rack, resulting in rust, abnormal wear and other phenomena inside the. If the internal water and sand are not disposed of immediately, the. Will be scrapped in a short time. Therefore, check the status of the dust-proof sheath at least once a month. If the sheath is damaged, it must be replaced immediately, and the steering machine shall be comprehensively inspected and maintained before replacement. After the toe in is adjusted by four-wheel positioning and the steering rod is changed, pay special attention to the deformation and improper assembly of the protective sleeve, otherwise the protective sleeve will be damaged. The lubricating grease will gradually become dirty and deteriorated during use, which will reduce the lubricating capacity; meanwhile, the materials under wear will gradually increase, and the wear phenomenon of abrasive particles will become more and more serious, which will aggravate the wear of. Every 100000 km or so, the. Shall be fully maintained, cleaned and re greased. Due to the poor service conditions and heavy load, the. Must be equipped with special lubricating grease, which can not meet the use requirements. The middle clearance of the steering wheel will gradually increase in use. If the left and right empty stroke of the steering wheel exceeds 15 degrees, the steering wheel must be inspected. If the abnormal wear of the gear rack is serious, the steering wheel assembly must be replaced. If there is no abnormal wear, but the clearance is too large, it can be adjusted. During the adjustment, it shall be carried out by trained professionals at the service station. After the adjustment, it shall be ensured that the steering wheel can be turned left and right to the limit position, with even force and flexible rotation. Do not carry out the maintenance and repair of the steering machine at the roadside shop with simple equipment and low technical level. If the steering machine is not adjusted properly, it will cause jamming and endanger the driving and personal safety. Compatible with the following vehicles. MAKE MODEL YEAR RANGE SPECIFIC DETAILS DODGE RAM 1500 2006 – 2012 All Models – Fits Both 2WD & 4WD DODGE RAM 2500 2006 – 2012 DODGE RAM 2500 2007 – 2008 2WD Models ONLY DODGE RAM 3500 2006 – 2012 DODGE RAM 3500 2007 – 2008 2WD Models ONLY. Rack & Pinion Complete Unit, Steering Rack, Steering Gear. Top performance For long service life. Backed by satisfying after-sales service. Corrosion and rust prevention. Rotate quickly and normal position. Power Steering Rack, Steering Rack and Pinion. Rack replacement kit, rack and pinion, power rack parts. The note there will NOT be read. The images shown are not the actual item and are for your reference only. There are NO EXCEPTIONS! OR, you may choose to have a replacement. FEEDBACK IS VERY IMPORTANT TO US. Steering Rack 32131094311 32131096144 For Bmw 5Er E39 520D/520I/523I/525D/525I. Fits 2003-08 HONDA PILOT View Door Mirror Glass Right RH Side Non-Heated. For 00-04 Toyota Tundra 3.4L Air Fuel Ratio 02 Sensor Upstream Downstream 2pcs. Starter For Chevy 2.2L S10 02 03 Monte Carlo 3.4L Venture Impala 2001-05 SDR0189. 2 Front Hood Gas Lift Supports Shock Struts Props For Ford Explorer 2002 to 2010. New Starter For Ford Mercury Crown Victoria Lincoln Mark Series 4.6L SFD0028. Starter For Polaris & Drive 300 Big Boss 250 Scrambler Sportsman 400 3085393. UTV & ATV Brake System Parts. Kevlar Carbon Brake Pads. Cylinder Head Gasket Sets. Cylinder Piston Gasket Sets. Brake Rotors & Pads. Brake Rotors Pads Kit. Idle air control valve. Secondary Air Injection Pump. Spark Plug Ignition Wire. Oil Fuel Hose Line. Fuel Injector Wiring Harness. Rear Window Louver Cover. Cold air intake kit. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Steering & Suspension\Gearboxes, Rack & Pinions”. The seller is “autoparts-leader” and is located in this country: US. This item can be shipped to United States.
- Brand: leader
- Manufacturer Part Number: AP17101501P
- Type: Rack & Pinion Complete Unit,Steering Rack,Steering Gear
- Greasable or Sealed: Greasable and Sealed
- Fitment Type: Performance/Custom
- Transmission Type: Automatic
- Mounting Hardware Included: as the picture
- Material: High Quality Steel
- Features: Greasable
- Surface Finish: Polished,Rust Protected
- itment Note: Top performance For long service life
- Note: Backed by satisfying after-sales service
- Rack Material: corrosion and rust prevention
- Advantage: Rotate quickly and normal position
- Steering Rack type: Hydraulic
- Part Number: Power Steering Rack,Steering Rack and Pinion
- Manufacturer Warranty: 3 Years
- packing: Dust plug
- Superseded Part Number: 22-382,Rack 5172
- Interchange Part Number: 55366-383AD-AE,5154494AA
- For: DODGE\nRAM 2500 2007-2008 2WD Models ONLY
- Fits: DODGE RAM 2500 2007-2008 2WD,DODGE RAM 3500 2006-2012
- Other Part Number: Steering gear
- OE/OEM Part Number: rack replacement kit,rack and pinion,power rack parts